RockKrawler joints.

[40inchDozer]

So I recently replaced my rear crawler joints on Tonka.what a world of difference.

[WhiteRavenRR]

Did you replace with new Krawler joints or did you upgrade to their Monster Pros?

[40inchDozer]

I replaced my old system joint to there newest ones. they are way better design and they are greasable.

[40inchDozer]

im trying to put up pics but Its not letting me. lol

[40inchDozer]

Joints before the instail.

[40inchDozer]

Instailled joint pics

[Rexx19]

are these pics from your phone? did you get the app to work?

[40inchDozer]

Rexx19 they are from my phone but only some worked without an error and other problem is i can only post one at a time. that takes forever when u have like 20 to post.

[40inchDozer]

only major problem i had was getting the old joints out of the control arms. but with a large monkey wrench and a large open end wrench on the jam nut i was able to break them free and get them out.

[WhiteRavenRR]

Yes they are very tight. I had to use a large crescent wrench and about a 15lb sledge plus my neighbors help. We placed the arms in a vise and almost broke the table it was attached to by the time we broke all 8 arms loose.

[JeepLab]

did you guys use 242 locktite when you put the ends back in?

[WhiteRavenRR]

I used loctite on the jam nut when setting the torque on it.

[40inchDozer]

never seize on the threads that go into the arm and then locktight on the jam nut. and im using a marine grease in the joints.

[Rexx19]

what did you guys spend? do you have to do this every few years?