Close

  • AMP Powerstep and possible remote operation if I can find a reverse ground signal

    Results 1 to 10 of 55

    Threaded View

    Previous Post Previous Post   Next Post Next Post
    1. 06-05-2014, 01:21 PM #2
      Timmy
      Timmy is offline
      Senior Member Timmy's Avatar
      Join Date
      Apr 2014
      Location
      Spokane, WA
      Posts
      288
      Doing some research on solutions, I'm not REAL technical, but is this where a relay comes in to help? Is that what I need to put in line on the hot wire to the LED light, and then the other side of the relay connects to the powerstep signal wire and then to the ground wire of the vehicle?

      Last edited by JeepLab; 06-05-2014 at 01:40 PM.
      2014 Jeep JKU Sahara, Manual - /OlllllllO\ - 4" Metal Cloak lift, 37" Toyo Open Country's on 20" XD Bully Rims, 4.56 Yukon gears, Mopar High Top Fenders, ARB Front Bull Bar Bumper, ARB Rear Bumper, Teraflex HD Tire Carrier, Teraflex Tire Carrier Accessory Mount, Twin Rotopax mount, Hi-Lift Jack mounted on front bumper, Reverse LED work lights, Warn 9.5ti winch, Synergy Drag Link, Trackbar Relocation Bracket, AMP Power Steps, JK1001 Radio, SpiderShade.
      Reply With Quote Reply With Quote
    « Previous Thread | Next Thread »

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •  

    Forum Rules