CertiFLAT Welding Table Build FAB BLOCK

[JeepLab]

Here we are mocked up. Did it in about 10 min.



Once mocked up, I put the threaded rods in, you see im short one. Thats where I hit the wall today.



This only holds it in one direction, so I added some pipe clamps



Finally I put on the corners and bolted them



I made everything hand tight and then put the square on it, and I couldnt find anything to correct. Thats how tight the lazer cuts are. Normally I have to mod everything a little, not so here. Very refreshing. Now if I only had another threaded rod.......