Thanks. It's good to be here. With the liners out it could use a bit more trimming to even it out and make it more flush.
Thanks. It's good to be here. With the liners out it could use a bit more trimming to even it out and make it more flush.
Yes that is the factory flares custom cut by myself. I wanted to keep with the factory flare lines so I taped off just inside of the upper curve. I only lost maybe 1/4-1/2" in width but gained the height of the downward angle of the flares. I also wanted a nice looking front end on them and spent the time taping them off until I was happy with the look. Like any cutting on the Jeep, it takes more time working up the courage than the actual work.
I also had to cut 2" off the front of the frame for the front bumper.
I just cut my seem.
I got some dirt in it, then washed it, so that foam inside was wet maybe... then I packed it with JB weld,
Am I going to rust my body out?
Connect With Us