I didn't have time to plumb the PCV to the can. But I did have time to plumb the make-up air line. The make-up air runs from the CAI (in my case an AFE) to the driver's (left) side valve cover (in the very, very, very tightest spot imaginable). So I took out the plastic line and long hose and made a two piece stainless steel 1/2 inch O.D. line. I needed to make it in two pieces because I couldn't snake a single hard line into place.
Here's another picture of the tubing bender I used.
It makes bends like this, which happens to be one of the finished section of new line:
In this picture we are "beading" the end of the pipe to create the bump that holds hose with a clamp.
Here's a closer pic of the tube with beaded end:
Connect With Us